iHome NB464 käyttöohje

iHome NB464
(1)
  • Sivuluku: 2
  • Tiedoston tyyppi: PDF
  • Using Your New Balance Sport Headphones with Foldable Neck Band
    Your New Balance Headphones feature a foldable neckband for compact storage. Unfold the neckband
    completely and place it over your head and behind your neck as shown with the earpieces over your ears
    and the headphone plug on your left side.
    Your New Balance Sport Headphones are
    supplied with two additional sets of plastic
    color caps to allow you to customize the
    look to match your mood. To replace the
    original caps simply lift up the edge of the
    cap as shown to remove it. Install a new
    cap and gently press down on the cap until
    it ‘snaps’ into place.
    Your New Balance Sport Headphones are also supplied
    with two sets of silicon speaker covers. You may wish to
    replace the original sponge speaker covers with the
    washable silicon speaker covers if you perspire heavily
    during exercise.
    To replace the speaker covers, carefully lift the sponge
    covers off the speaker housing and then stretch the silicon
    covers over the housing.
    Your New Balance Sport Headphones were designed with a modular cord system. We have provided a 15”
    iPod/iPhone control cable that is suitable if your music player will be worn in an armband or clipped to your
    clothing at chest level. We have also provided a 36” cable that is suitable if your music player will be clipped
    to your belt, placed in your pocket or carried in a fanny-pack. You may connect both cables together in
    case you want to control your iPod or iPhone and the 15” or 36”cable is not long enough.
    Connect the male headphone plug of the headphones to the female headphone jack of either the 15” or
    36” headphone cable depending on your wearing preference. Then connect the male headphone plug of
    the 15” or 36” cable to the headphone jack of your music player. Be sure that the plugs are fully inserted
    into the jacks. If the plugs are not fully inserted you may only hear sound from one earpiece.
    Using the iPod/iPhone Control Cable
    Connect the 15” iPod/iPhone cable between your headphones and your iPod/iPhone to perform the
    following operations with the remote controller mounted on the cable:
    Model: NB464 (Front) (REV 1 )
    Print color : Black text on white paper
    Size of manual: 140mmW x 280mmH
    Date: July 15, 2010

    Model: NB464

    Behind-The-Neck

    Sport Headphones

    To Do This Action Required
    Activate voice control* Depress the Master Control for 2 seconds
    Answer or end a call Press the Master Control once to answer call
    Press the Master Control again to end call
    Ignore an incoming call Depress the Master Control for 2 seconds
    Answer a second incoming call Press the Master Control once to answer second call
    and place original call on hold Press the Master Control again to return to first call
    Answer a second incoming call, Depress the Master Control for 2 seconds
    and end original call 2 low tones will confirm end of original call.
    Switch between two calls Press the Master Control once to switch between calls
    Play or Pause Press Master Control once to Play, again to Pause
    Skip Track or Chapter Forward Press Master Control 2 times quickly
    Skip Track or Chapter Back Press Master Control 3 times quickly
    Increase Volume Press the "+" button
    Decrease Volume Press the " - " button
    Activate VoiceOver** Press and hold the Master Control to hear title and
    artist of currently playing song
    Navigate Playlists using VoiceOver** Press and hold the Master Control until tone is heard,
    then release. When the name of the desired playlist is
    heard, press the Master Control once to select it.
    Click to Increase
    Volume
    Click x2 for Next Track
    Click x3 for Previous Track
    Press + Hold for iPod
    Shuffle VoiceOver
    Click to Decrease
    Volume
    Click to Play/Pause
    Master Control
    NB464-071410-A
    Printed in China
    New Balance Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this
    product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 2
    years from the date of original purchase.
    Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally
    purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction
    during the warranty period, SDI Technologies will repair or, at its discretion, replace this product without charge (except
    for a $2.00 charge for handling, packing, return UPS/postage, and insurance). This decision is subject to verification
    of the defect or malfunction upon delivery of this product to the Factory Service Center listed below. The product must
    include proof of purchase, including date of purchase. The fee for service without proof of purchase is $4.00.
    Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted
    or defective batteries are the most common cause of problems encountered.
    If service is still required:
    1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box.
    2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within
    the warranty period.
    3. Enclose a check or money order payable to the order of SDI Technologies, for the sum of $2.00 ($4.00 without
    proof of purchase).
    4. Send the unit prepaid and insured, to the Factory Service Center listed below.
    Consumer Repair Department
    SDI Technologies Inc. 1330 Goodyear Drive
    El Paso, TX 79936-6420
    Disclaimer of Warranty
    NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover
    (i) products which have been damaged by negligence or willful actions, misuse or accident, or which have been
    modified or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat;
    (iii) damage to digital media players, CD’s or tape cassettes (if applicable); (iv) the cost of shipping this product to the
    Factory Service Center and its return to the owner.
    This warranty is valid only in the United States of America and does not extend to owners of the product other than
    to the original purchaser. In no event will SDI Technologies or any of its affiliates, contractors, resellers, their officers,
    directors, shareholders, members or agents be liable to you or any third party for any consequential or incidental
    damages, any lost profits, actual, exemplary or punitive damages. (Some states do not allow limitations on implied
    warranties or exclusion of consequential damages, so these restrictions may not apply to you.) This warranty gives
    you specific legal rights, and you may also have other rights which vary from state to state.
    Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty
    is contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase
    of your SDI Technologies product.

    Limited 2 Year Warranty

    Model: NB464 (Back) (REV 1 )
    Print color : Black text on white paper
    Size of manual: 140mmW x 280mmH
    Date: July 15, 2010
    Using the Water Resistant Connection Cover
    Your New Balance Ear Buds are also supplied with a silicon sleeve that can be used to cover the
    connection between the male headphone plug on the Ear Buds and the female headphone jack on the 15”
    or 36” cable. Use this connection cover if you routinely use your Ear Buds in extremely wet or damp
    conditions.
    Stretch the connection cover over the plug of the Ear Buds as shown.
    After connecting the male plug of the Ear Buds to the female jack on the
    15” or 36” cable. Slide the connection cover down so that it completely
    covers the plug and jack connection point to seal out excess moisture.
    Safety Information
    To protect your hearing, always start listening with the Volume Control of
    your music player set to a low level and gradually increase the volume to
    a comfortable listening level.
    IMPORTANT! Listening at high volume for long periods of time can result
    in long-term hearing damage. For your safety, do not use headphones if
    they would prevent you from hearing warning sounds, such as while
    driving a car or motorcycle, riding a bike, etc.
    NOTE: In extremely cold or dry air conditions you may notice a slight
    ‘tingling’ feeling in your ears when using in-ear headphones. This is the
    result of the build-up of static electricity in your body. This is normal and
    not an indication of any problem with your headphones.
    Using the Accessory Cord Winder Clip
    Your New Balance Ear Buds are also supplied with a cord winder clip that may be used to eliminate excess
    slack in the 36” cable if necessary. If you find that that the 36” cable is too long you can store up to 24” of
    cable in the cord winder and then clip the cord winder to your clothing.
    Authorized Licensee of New Balance Athletic Shoe, Inc. New Balance and Flying NB are registered
    trademarks of New Balance Athletic Shoe, Inc
    © 2010 SDI Technologies, Inc. All rights reserved
    Questions? Visit www.newbalanceaudio.com or
    call 1-800-288-2792 Toll Free.
    close the cord winder
    wrap cord clockwise around the
    spool to reach desired length
    open the cord winder
    using the small tab
    under the clip
    pass the plug down
    and through the cover
    clip it on and go!
    wind over
    20 inches!
    pull the cord back up
    and over the spool
iHome NB464

Tarvitsetko apua?

Kysymysten lukumäärä: 0

Onko sinulla kysyttävää tuotteesta iHome NB464 tai tarvitsetko apua? Esitä kysymyksesi täällä. Anna selkeä ja kattava kuvaus asiasta ja kysymyksestäsi. Mitä yksityiskohtaisemmin kuvaat asiaasi ja kysymystäsi, sitä helpompi muiden iHome NB464 omistajien on vastata kysymykseesi oikein.

Katso iHome NB464 käyttöohjeet täältä ilmaiseksi. Tämä opas kuuluu luokkaan Kuulokemikrofonit, ja sen on arvioinut 1 ihmistä keskimäärin arvosanalla 7.5. Tämä opas on saatavana seuraavilla kielillä: Englanti. Onko sinulla kysyttävää tuotteesta iHome NB464 tai tarvitsetko apua? Esitä kysymyksesi täällä

iHome NB464 – tekniset tiedot

Yleistä
Tuotemerkki iHome
Malli NB464
Tuote Kuulokemikrofoni
EAN 0047532894462
Kieli Englanti
Tiedoston tyyppi PDF

Usein Kysytyt Kysymykset

Alta löydät useimmin kysytyt kysymykset aiheesta iHome NB464.

Eikö kysymystäsi ole listassa? Esitä kysymyksesi täällä