MSR DragonFly käyttöohje

MSR DragonFly
(1)
  • Sivuluku: 2
  • Tiedoston tyyppi: PDF
  • M OUNTAIN S AFETY R ESEARCH
    8. Put Flame Adjuster Handle onto
    DragonFly Cleaning Tool.
    Insert tool into Flame Adjuster Tube
    and rotate clockwise with pressure
    (approximately 20 turns).
    9. Tap Flame Adjuster Tube on a hard
    surface to remove loosened deposits.
    10.
    Reinsert Flame Adjuster Valve
    Assembly and tighten securely.
    11.
    Flush the Fuel Line.
    Connect stove to Pump
    and Fuel Bottle.
    Pressurize Fuel Bottle with 10-15
    strokes.
    Fully open Pump Control Valve
    and Flame Adjuster Valve to flush
    4 spoonfuls of fuel through Fuel Line
    into an appropriate container.
    (Jet uninstalled.)
    WARNING: Keep away from
    ignition sources.
    Close and reopen Flame Adjuster
    Valve to repeat flushing.
    Close Flame Adjuster Valve and
    Pump Control Valve and remove
    Fuel Line.
    Safely dispose fuel when flushing
    is complete.
    12.
    Reassemble stove.
    If stove performance is still impaired,
    repeat Cleaning the Jet and Flame
    Adjuster Valve Assembly steps.
    O-rings can become dry, cracked or torn
    with use. Their lifespan is affected by dirt,
    debris, temperature, friction and frequency
    of use. For this reason, please inspect your
    O-rings before every trip. Replace dry,
    cracked, or torn O-rings immediately, and
    replace all O-rings annually, regardless
    of appearance. Replacement O-rings and
    Pump Seals can be found in the Annual
    Maintenance Kit, or the more comprehensive
    Expedition Service Kit, purchased separately
    from an MSR
    ®
    dealer.
    REPLACING FUEL TUBE O-RING
    1. Remove Plunger.
    Align, twist, and pull.
    2. Remove Fuel Tube Bushing and O-ring
    with Jet and Cable Tool.
    Remove the O-ring with the end of the
    Fuel Line or Safety Pin.
    3. Inspect O-ring and replace if damaged.
    If needed, a spare green Fuel Tube
    O-ring is provided.
    4. Lubricate Pump Cup.
    Use a drop of Pump Cup Oil or any
    mineral-based oil.
    5. Insert Plunger.
    Hold thumb and forefinger firmly
    around Arrow 1.
    Align Plunger Bushing Tabs with
    holes in Pump Body.
    Push Plunger/Bushing into the
    Pump Body until it snaps in place.
    CLEARING THE JET WITH THE SHAKER NEEDLE
    1. Close Pump Control Valve and wait
    5 minutes for stove to cool.
    2. Shake stove up and down.
    Shaker Needle inside Jet should rattle.
    3. Preheat and run stove.
    If performance does not improve,
    perform Cleaning the Jet and
    Flame Adjuster Valve Assembly steps.
    CLEANING THE JET AND
    FLAME ADJUSTER VALVE ASSEMBLY
    1. Remove Flame Spreader.
    2. Unscrew Jet with Jet and Cable Tool.
    Use DragonFly Cleaning Tool with Jet
    and Cable Tool for added leverage.
    3. Remove Shaker Needle.
    NOTE: To exchange Jets, place Shaker
    Needle in new Jet and reassemble stove.
    4. Clear Jet with Jet Cleaning Wire.
    5. Open Flame Adjuster Valve 2 turns.
    6. Loosen Stop Nut with Jet and Cable Tool.
    Unscrew Flame Adjuster Valve
    completely.
    Remove Flame Adjuster Valve Assembly.
    7. Clean grooved end of Flame Adjuster
    with thumbnail or Jet Cleaning Wire.

    INSTRUCTION

    MANUAL

    DRAGONFLY

    ®
    For product service and information contact
    Cascade Designs, Inc.
    4000 First Avenue South, Seattle, WA 98134 USA
    Phone: 800.531.9531 or 206.505.9500
    www.msrgear.com
    ART# 33-305-2 | EN
    FOR OUTDOOR USE ONLY
    PUMP MAINTENANCE STOVE MAINTENANCE
    TROUBLESHOOTING
    FUEL INFORMATION
    The DragonFly
    ®
    stove burns a variety of fuels by using two interchangeable Jets.
    1. The DG Jet is used for White Gas and Unleaded Auto Gas. This Jet is preinstalled in your stove.
    2. The DK Jet is for Kerosene, Diesel, and Jet Fuel. This Jet is included in the parts kit with your stove.
    To exchange Jets, see “Cleaning the Jet and Flame Adjuster Valve Assembly.”
    Use MSR
    ®
    SuperFuel
    (White Gas) for optimal performance. It is the highest quality fuel available for your stove.
    Do not use leaded fuels. Fuels other than MSR SuperFuel white gas lead to rapid stove clogging and require
    more frequent Jet and Fuel Line cleanings. Also, the use of Unleaded Auto Gas may shorten stove lifespan. Use
    the fuels chart below to help you find your fuel when traveling internationally.
    Visit www.msrgear.com for more information on international fuel names and safe stove transportation.
    USA/UK/
    Canada
    Germany/
    Switzerland
    Japan France Netherlands Spain
    White Gas,
    Naphtha
    Kocherbenzin,
    Reinbenzin
    White Gas
    Pétrole à brûler,
    Essence C
    Wasbenzine
    Bencina
    blanca
    Unleaded
    Auto Gas
    Autobenzin Gasoline
    Essence sans
    plomb
    Benzine
    Gasolina sin
    plomo
    Kerosene Petroleum Toh-yu Kérosène
    Petroleum
    Lampolie
    Parafina
    Diesel Diesel Diesel Diesel Diesel Diesel
    Problem
    Leaking Fuel Cause Solution
    At Pump and Fuel Bottle Connection Damaged or missing Pump Seal Replace Pump Seal
    At Pump and Fuel Line Connection Damaged or missing Fuel Tube
    O-ring
    Replace Fuel Tube O-ring
    At Control Valve Stem Damaged or missing
    Control Valve O-ring
    Replace Control Valve O-ring
    In Pump Plunger Chamber Obstructed Check Valve Clean Check Valve Cavity
    Poor Performance Cause Solution
    Pump not pressurizing Fuel Bottle Loose or poorly seated Pump
    Damaged Pump Cup
    Tighten or rescrew Pump
    on Fuel Bottle
    Replace Pump Cup
    Plunger hard to pump Dry Pump Cup Lubricate Pump Cup
    Erratic yellow flames Improper preheating Repeat Step 4
    Diminished flames Low Fuel Bottle pressure Pump the Plunger
    Slow boil times Clogged Jet or Fuel Line Clear Jet and clean Fuel Line
    Diminished flames at altitude Insufficient airflow Open Windscreen slightly
    Jet and
    Cable Tool
    Remove O-ring
    CONTROL
    VALVE
    O-RING
    POPPET
    O-RING
    Unscrew
    Stop Nut
    TOP
    Remove/Replace
    Pump Seal
    Remove Check
    Valve Assembly
    Remove Plunger
    ALIGN TWIST PULL
    ALIGN
    POSITION
    Insert Plunger
    REPLACING CONTROL VALVE O-RING
    AND POPPET O-RING
    1. Unscrew Stop Nut 2 turns.
    2. Unscrew Pump Control Valve 6 turns.
    3. Unscrew Stop Nut completely and
    remove Control Valve Assembly.
    4. Inspect O-ring(s) and replace if damaged.
    Remove Pump Control Valve Handle
    from stem.
    Slide Stop Nut off.
    Remove O-ring(s) with Safety Pin.
    REPLACING PUMP SEAL
    Inspect Pump Seal and replace if
    damaged.
    CLEANING THE CHECK VALVE
    1. Turn Check Valve Assembly to remove.
    2. Wipe any debris from Check Valve
    and Pump Cavity.
    3. Reinsert Check Valve Assembly.
    Shake the
    Stove
    Remove Flame
    Spreader
    Unscrew
    the Jet
    Clear Jet
    Orifice
    Loosen
    Stop Nut
    Rotate
    Cleaning Tool
    Remove old
    Fuel Line Filter
    REPLACING THE FUEL LINE FILTER
    1. Remove old Fuel Line Filter with
    Safety Pin.
    2. Place new white Fuel Line Filter on
    a hard surface.
    Center end of Fuel Line over filter.
    Push end of Fuel Line until filter is
    completely inside.
    Deposits in the Jet and Fuel Line reduce fuel flow and impair stove performance. Minor
    deposits in the Jet can be cleared with the Shaker Needle. Major deposits may require more
    extensive cleaning of the Jet and Fuel Line. At a minimum, perform the following maintenance
    annually, or every time you perform the Pump Maintenance.
    Do not disassemble stove or pump beyond what is described in these instructions. Disassembly or modification of stove or pump in any manner not consistent with these instructions voids warranty and can result in an unsafe situation where fire, burns, severe injury or death can occur.
    Do not use stove or pump if parts are missing or broken, or with replacement parts not specific to your stove model. Use
    of stove with missing or broken parts, or with replacement parts not specific to your stove model, can result in an unsafe
    situation where fire, burns, severe injury or death can occur.
    WARNING
    Retain these instructions for future reference.READ, UNDERSTAND, AND FOLLOW ALL instructions and warnings in this manual before using this stove. Failure to follow warnings and instructions can result in death, serious burns or other injury, and property damage.
    CARBON MONOXIDE, FIRE & EXPLOSION HAZARD
    There are serious hazards associated with using this stove and fuel. Accidental fire, explosion, and misuse can cause death, serious burns, and property dam-age. You are responsible for your own safety and the safety of those in your group. Please use good judgment.This stove is for OUTDOOR USE ONLY. Never use this stove in a tent, vestibule, car, house, or inside any enclosed area. This stove consumes oxygen and pro-duces carbon monoxide gas, which is poisonous and has no odor. This stove can easily ignite nearby combustible materials and flammable liquids or vapors. If you use this stove in an enclosed area you can be killed or seriously burned.Keep stove and fuel bottle away from other heat sources. Never use cookware or an Outback Oven
    with a diameter larger than 10 inches (25 centimeters). Oversized cookware can overheat the fuel bottle. If you expose the fuel bottle to high heat, it will explode and you can be killed or seriously burned.Never let children use this stove. Keep children at least 10 feet (3 m) away from the stove and cooking area, and supervise them at all times.

    DANGER

    FOR YOUR SAFETY

    CARBON MONOXIDE HAZARD

    This stove produces carbon mon-

    oxide, which has no odor. Using

    it in an enclosed space can kill

    you. Never use this stove in an

    enclosed space such as a camp-

    er, tent, car, or home.

    Do not store or use gasoline or other liquids

    with flammable vapors in the vicinity of this or

    any other stove.

    DANGER

MSR DragonFly

Tarvitsetko apua?

Kysymysten lukumäärä: 0

Onko sinulla kysyttävää tuotteesta MSR DragonFly tai tarvitsetko apua? Esitä kysymyksesi täällä. Anna selkeä ja kattava kuvaus asiasta ja kysymyksestäsi. Mitä yksityiskohtaisemmin kuvaat asiaasi ja kysymystäsi, sitä helpompi muiden MSR DragonFly omistajien on vastata kysymykseesi oikein.

Katso MSR DragonFly käyttöohjeet täältä ilmaiseksi. Tämä opas kuuluu luokkaan Grillit, ja sen on arvioinut 1 ihmistä keskimäärin arvosanalla 7.5. Tämä opas on saatavana seuraavilla kielillä: Englanti. Onko sinulla kysyttävää tuotteesta MSR DragonFly tai tarvitsetko apua? Esitä kysymyksesi täällä

MSR DragonFly – tekniset tiedot

Yleistä
Tuotemerkki MSR
Malli DragonFly
Tuote Grilli
Kieli Englanti
Tiedoston tyyppi PDF
Ominaisuudet
Tuotetyyppi Nestekaasukeitin
Savuton -
Vyöhykkeiden määrä 1 alue(tta)
Lämmönlähde Maakaasu
Kokoontaitettava Kyllä
Helposti puhdistettava Kyllä
Käyttöaika (min.) 126 min
Käyttöaika (maks.) 153 min
Kiehumisaika 3.5 min
Tuotteen väri Hopea
Paino ja mitat
Tuotteen syvyys 101.6 mm
Tuotteen leveys 101.6 mm
Paino 399 g
Pakkauksen paino 510 g
Tuotteen korkeus 152.4 mm
Näytä lisää

Usein Kysytyt Kysymykset

Alta löydät useimmin kysytyt kysymykset aiheesta MSR DragonFly.

Eikö kysymystäsi ole listassa? Esitä kysymyksesi täällä